Success! OBDII Engine RPM Display Working
Posted November 3, 2009
on:- In: News | OBDII | On-Board Diagnostic System
- 1 Comment
Well, I have produced a very early prototype this week, just to make sure that my project is going to viable! Don’t want to get all the way to January and realise that I can’t code the damn thing.
So for anybody that’s interested here’s a screen shot of the prototype.
The prototype was written in Embarcadero RAD Studio AKA Delphi 2010, uses an ELM327 serial to USB interface (38400 Baud Rate) purchased from Ebay for about £15. Theres no data on the screen because it’s not connected to the car (it was raining) 🙂 but it does work.
I managed to get the timer down to 100 ms with no errors, so I will see if I can push it further next time I’m testing it. If anybody knows what the minimum ms is please post a comment below. I know that it varies with every ECU, but whats the general figure that works 99% of the time with most cars.
1 | Nick
November 25, 2009 at 04:13
I am attempting the same thing but i havent tried to code it yet. I’m using visual studio. i was wondering if you could send me a copy of the source code where you retrieved the data from the ecu.